Technicolor - Thomson ST585 V6 - Manual (Page 451)

E-DOC-CTC-20061027-0004 v1.0
IP Commands
427
22 IP Commands
Introduction
This chapter describes the commands of the ip command group.
Contents
This chapter covers the following commands:
ip arpadd Add an entry to the ARP cache of a broadcast Internet Protocol
(IP) interface. 429
ip arpdelete Delete an entry from the ARP cache. 430
ip arplist Display the ARP cache. 431
ip config Show/set global IP stack configuration options. 432
ip flush Flush all the static IP parameters. 434
ip ifadd Create an IP interface. 435
ip ifattach Attach an IP interface. 436
ip ifconfig Configure the parameters of an IP interface. 437
ip ifdelete Delete an IP interface. 439
ip ifdetach Detach an IP interface. 440
ip iflist Display all the IP interfaces. 441
ip ifwait Wait for a status change of an IP interface. 442
ip ipadd Assign an IP address to an IP interface. 443
ip ipconfig Modify an IP address configuration. 444
ip ipdelete Remove an IP address from an IP interface. 445
ip iplist Display all the configured IP addresses. 446
ip mcast rtadd Add a multicast route to the multicast routing table. 447
ip mcast rtdelete Delete a multicast route from the multicast routing table. 448
ip mcast rtlist Display the multicast routing table. 449
ip mcast flush Flush the multicast routing table. 450
ip rtadd Add a route to the routing table. 451
ip rtdelete Delete a route from the routing table. 453
ip rtlist Display the routing table. 454
ip auto flush Flush the autoIP interfaces. 455
ip auto ifadd Create an autoIP interface. 456
ip auto ifattach Select and assign a link-local address to an autoIP interface. 457
ip auto ifconfig Configure an autoIP interface. 458
ip auto ifdelete Delete an existing autoIP interface. 460
ip auto ifdetach Release the link-local address for the given autoIP interface. 461
ip auto iflist Display the autoIP interfaces. 462
ip debug httpprobe Send a HTTP probe. 463