Technicolor - Thomson ST585 V6 - Manual (Page 595)

E-DOC-CTC-20061027-0004 v1.0
NAT Commands
571
nat maplist
Display the address mapping for a NAT enabled interface.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
nat maplist [intf = <string>]
[expand = <{disabled | enabled}>]
intf The IP interface name.
Note If not specified, the address mapping for all the NAT
enabled interfaces will be shown.
OPTIONAL
expand Enable or disable expanded listing.
The default is
disabled .
OPTIONAL
=>nat maplist
Idx Type Interface
Outside Address Inside Address Use
1 NAPT myPPP_ppp 100.100.100.1 unmapped 0
1 NAPT eth0 any:80 127.0.0.1:8080 0
2 NAPT eth0 any:1080 127.0.0.1:8080 0
3 NAPT eth0 any:8080 127.0.0.1:8080 0
=>maplist intf=myPPP_ppp expand=enabled
Idx Type Interface
Outside Address Inside Address Use
1 NAPT myPPP_ppp 100.100.100.1 unmapped 0
Access List................... 10.0.0.0/24
Foreign Address............... any
Protocol...................... any
Flags......................... Static
Description................... Outbound NAPT without defserver
=>
nat mapadd Add an address mapping to a Network Address Translation (NAT) enabled
interface.
nat mapdelete Delete an address mapping from a NAT enabled interface.