Technicolor - Thomson ST585 V6 - Manual (Page 332)

E-DOC-CTC-20061027-0004 v1.0
Eth Commands
308
eth switch mirror capture
Define the specified port to be the Mirror Capture Port.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
i
Only one port can be the Mirror Capture Port at any one time.
eth switch mirror capture port = <number{1-4}>
port The port to be the Mirror Capture Port.
Note If no port number is specified, then the port number of
the Mirror Capture Port is shown.
REQUIRED
=>eth switch mirror capture port=2
=>eth switch mirror capture
Mirror capture port = 2
=>
eth switch mirror egress Enable or disable the specified port to be the Mirror Egress Port.
eth switch mirror ingress Enable or disable the specified port to be the Mirror Ingress Port.