Toshiba H1 SERIES TLCS-900 - Manual (Page 119)

TMP92CM22
2007-02-16 92CM22-117
(4) 8-bit PWM (Pulse width modulation) output mode
This mode is only valid for TMRA0. In this mode, a PWM pulse with the maximum
resolution of 8 bits can be output.
When TMRA0 is used the PWM pulse is output on the TA1OUT pin (which is also
used as PC1). TMRA1 can also be used as an 8-bit timer.
The timer output is inverted when the up counter (UC0) matches the value set in
the timer register TA0REG or when 2 n counter overflow occurs (n = 6, 7, or 8 as
specified by TA01MOD<PWM01:00>). The up counter UC0 is cleared when 2 n counter
overflow occurs.
The following conditions must be satisfied before this PWM mode can be used.
Value set in TA0REG < Value of set for 2
n counter overflow
Value set in TA0REG ≠ 0
Figure 3.7.16 8-Bit Output Wave Form
Figure 3.7.17 shows a block diagram representing this mode.
Figure 3.7.17 Block Diagram of 8-Bit PWM Output Mode
Match with
TA0REG and UC0
TA1OUT
t PWM
(PWM cycle)
2 n
overflow
(Interrupt INTTA0)
Selector
8-bit up counter
(UC0)
Comparator
TA0IN
φT1
φT4
φT16
TA01MOD<TA0CLK1:0>
TA1FF
TA0REG
Register buffer
Selector
TA01RUN<TA0RDE>
TA0REG-WR
TA01RUN<TA0RUN>
TA1OUT
TA1FFCR
<TA1FFIE>
Shift trigger
Internal data bus
Clear
2 n overflow
control
INTTA0
TA01MOD
<PWM01:00>
Overflow
Inversion