Toshiba H1 SERIES TLCS-900 - Manual (Page 212)

TMP92CM22
2007-02-16 92CM22-210
Example:
1. Convert the analog input voltage on the AN3 pin and write the result, to memory
address 0800H using the AD interrupt (INTAD) processing routine.
Setting of main routine
7 6 5 4 3 2 1 0
INTE0AD
← X 1 0 0 − − − −
Enable INTAD and set it to interrupt level 4.
ADMOD1 ← 1 1 0 0 0 0 1 1 Set pin AN3 to the analog input channel.
ADMOD0 ← X X 0 0 0 0 0 1 Start conversion in channel fixed single conversion
mode.
Interrupt routine processing example
WA
← ADREG3
Read value of ADREG3L, ADREG3H to general
purpose register WA (16 bits).
WA > > 6 Shift contents read into WA six times to right and zero-fill
upper bits.
(0800H)
← WA
Write contents of WA to memory address 0800H.
2. Converts repeatedly the analog input voltages on the three pins AN0, AN1, and
AN2, using channel scan repeat conversion mode.
INTE0AD
← X 0 0 0 − − − − Disable
INTAD.
ADMOD1 ← 1 1 0 0 0 0 1 0 Set pins AN0 to AN2 to be the analog input channels.
ADMOD0
← X X 0 0 0 1 1 1
Start conversion in channel scan repeat conversion
mode.
X
: Don’t care, − : No change