Toshiba H1 SERIES TLCS-900 - Manual (Page 81)

TMP92CM22
2007-02-16 92CM22-79
3.6.2 Control Register and Operation after Reset Release
This section describes the registers to control the memory controller, the state after reset
release and necessary settings.
(1) Control register
The control registers of the memory controller are as follows.
• Control register: BnCSH/BnCSL (n = 0 to 3, EX)
Sets the basic functions of the memory controller, that is the connecting
memory type, the number of waits to be read and written.
• Memory start address register: MSARn (n = 0 to 3)
Sets a start address in the selected block address areas.
• Memory address mask register: MAMRn (n = 0 to 3)
Sets a block size in the selected address areas.
In addition to setting of the above-mentioned registers, it is necessary to set the
following registers to control ROM page mode access.
• Page ROM control register: PMEMCR
Sets to executed ROM page mode accessing.
(2) Operation after reset release
The start data bus width is determined depending on state of AM1 and AM0 pins
just after reset release. Then, the external memory is accessed as follows.
AM1 AM0 Start Mode
0 0 Don’t use this setting
0 1 Start with 16-bit data bus
1 0 Start with 8-bit data bus
1 1 Don’t use this setting
AM1/AM0 pins are valid only just after reset release. In the other cases, the
data bus width is set to the value set to BnBUS bit of the control register.
By reset, only control register (B2CSH/B2CSL) of the block address area 2 is
automatically effective (B2CSH<B2E> is set to “1” by reset).
The data bus width which is specified by AM1/AM0 pin is loaded to the bit to
specify the bus width of the control register in the block address area 2.
The block address area 2 is set to address 000000H to FFFFFFH by reset.
After reset release, the block address areas are specified by the memory start
address register (MSAR) and the memory address mask register (MAMR). Then
the control register (BnCS) is set.
Set the enable bit (BnE) of the control register to “1” to enable the setting.