GE Industrial Solutions AF-300C AC Drive - Manual (Page 126)

AUXILIARY
PARAMETER
(continued)
FUNCTION CODE SETTINGS: Factory and Field
Factory Field
Code Name Ranne Settinq Settinq
Motoring Torque Limit 1 % 1 5 0 %
Braking Torque Limit % 1 % 1 0 0 %
Freq. Detection Threshold 1 400 1 30 Hz
Freq. At Reference 0.5 5.0 0.1 2.5 Hz
37 Frequency -5.0 Hz 0.1 Hz 0.5
38 Frea. Holdina Time 10.0
I I
0.1
I 0.0 I
‘Jump Frequency 1 0.1 0.0 Hz
Jump Frequency 2 0.0, 0.5 400.0 0.1 Hz 0.0
Jump Frequency 3 0.0, 0.5 400.0 H Z 0.1 0.0
Freauencv Ranae 0.0 5.0 H Z 0.1 2.0 Hz
Motor Poles 10.
I --- I I I
4 0
41
Coefficient Mach Spd. 0.1 10.0 0.1 1.0
‘Pulse Freq. Meter Coeffic. 6 1 0 0 1 30
Cmd. Hold Yes No --- --- Yes
(3 wire control)
Up Down Control Yes (0), No
Restart After Power Fail Yes (0), No
Under Voltage Alarm Yes (0), No
Output Select 0,
Control 0.0 -2.5
--- --
---
---
--- ---
0.1 Hz
.
Yes (0)
0
0.0 Hz
47
ADJUSTMENT
PARAMETER 50
PROTECTION 99
Sig. Polarity Op. Yes (0), No - -
Meter Calibration 70.0 105.0 %
Set Data Protection Yes (0), No
Fault Message Ind. Failure Condition - -
Output Frequency at Fault Hz
Setting Frequency at Fault Hz
Current at Fault A
Mode at Fault
I I
No
0.1% 160.0%
0.1 Hz ----
0.1 Hz ----
- - -
I I
F 5
F 6
Fault Memory 1
Fault Memory 2
Fault Memory 3
Because the data display is four digits, if the indication exceeds four digits it will be shown as of the actual
(Example: 12000 RPM would be displayed as 1200 RPM.)
These parameter values can be changed during operation; other parameters can only be changed when the
inverter is stopped.
If the setting of Acceleration/Deceleration time exceeds 100 seconds, the minimum setting unit resolution will become
1 second.
Momentary power only (duration may vary with horsepower and load).
Consult distributor for operation above 120 Hertz.
Function Chanqes 2