GE Industrial Solutions AF-300C AC Drive - Manual (Page 20)

AF-300C GEK-85716
E D
Selection
Indicator
FUNCTION DATA
FAST
L O C A L
Figure 2-4. KEYPAD PANEL COMPONENT IDENTIFICATION
Unit
Indicators
LED Indicator -The LED Indicator is made up of
three sections as follows:
Function Display Displays in two digits the
selected Function Code number.
Data Display Displays in four digits the operation
data, Function Code setting data, and the fault
codes.
Unit Indicator The LED on the left of each unit
symbol corresponds to the contents of the data
display.
NOTE: All letters are in upper case
except and
Touch Kevs There are eleven Touch Keys and the LOCAL/REMOTE switch that perform the following
functions: (See Section 5 for a description of each individual key.)
Function Description
Operation Monitoring Monitor the operation status of the inverter.
Function Code Setting: Basic Function Codes Set data required for operation.
Auxiliary Function Codes Set data required for control.
Calibration Function Codes Adjust output signals to match with instruments
externally installed.
Fault Monitoring
Set Data Protection
Display and retrieval of the Fault Code and the
operating conditions at the time of the fault.
Protect set data against accidental modification.
Reset Data reset at Function Code setting, reset to returr
to operation monitoring mode after completing the
fault reset, and Error Reset.
Operation Mode Selection
I
Switch for changing between “Local” and “Remote’
modes of operation.
Operation Commands Forward, Reverse, and Stop commands can be
entered in the “Local” mode.
Frequency Setting Commands Increase and decrease reference frequency com-
mands can be entered in the “Local’ mode.
2-4