Asus GigaX2024SX - Manual (Page 139)

interfaces across the network.
• GARP – Group Address Registration Protocol is used by GVRP to register or
deregister client attributes for client services within a bridged LAN. The default
edia access method or data
rate. These values should not be changed unless you are experiencing difficulties
.
Command Attributes
terface must first be configured as an untagged member
group.
pt all frame types,
ember. (Default: Disabled)
frames will be discarded.
ect VLAN independent BPDU frames, such as
GVRP or STP. However, they do affect VLAN dependent BPDU frames, such as
e
discarded and no GVRP registrations will be
efault: Disabled)
• GARP Join Timer* – The interval between transmitting requests/queries to
60-3000 centiseconds; Default: 60)
val between sending out a LeaveAll query
message for VLAN group participants and the port leaving the group. This interval
values for the GARP timers are independent of the m
with GVRP registration/deregistration
• PVID – VLAN ID assigned to untagged frames received on the interface.
(Default: 1)
If an interface is not a member of VLAN 1 and you assign its PVID to this VLAN,
the interface will automatically be added to VLAN 1 as an untagged member. For
ll other VLANs, an in a
before you can assign its PVID to that
• Acceptable Frame Type – Sets the interface to acce
including tagged or untagged frames, or only tagged frames. When set to receive
all frame types, any received frames that are untagged are assigned to the default
agged; Default: All) VLAN. (Options: All, T
g – Determines how to process frames tagged for VLANs for • Ingress Filterin
which the ingress port is not a m
- Ingress filtering only affects tagged frames.
- If ingress filtering is disabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be flooded to all other ports (except for
those VLANs explicitly forbidden on this port).
- If ingress filtering is enabled and a port receives frames tagged for VLANs for
which it is not a member, these
- Ingress filtering does not aff
GMRP.
• GVRP Status – Enables/disables GVRP for the interface. GVRP must b
ect. (See “Displaying globally enabled for the switch before this setting can take eff
Bridge Extension Capabilities” on page 3-11.) When disabled, any GVRP packets
received on this port will be
propagated from other ports. (D
participate in a VLAN group. (Range: 20-1000 centiseconds; Default: 20)
• GARP Leave Timer* – The interval a port waits before leaving a VLAN group.
This time should be set to more than twice the join time. This ensures that after a
Leave or LeaveAll message has been issued, the applicants can rejoin before the
port actually leaves the group. (Range:
• GARP LeaveAll Timer* – The inter
should be considerably larger than the Leave Time to minimize the amount of
traffic generated by nodes rejoining the group.
(Range: 500-18000 centiseconds; Default: 1000)
3-114