Asus GigaX2024SX - Manual (Page 360)

4-192
the network or to connect the switch to existing IP subnets. You can manually
configure a specific IP address, or direct the device to obtain an address from a
BOOTP or DHCP server. Valid IP addresses consist of four numbers, 0 to 255,
separated by periods. Anything outside this format will not be accepted by the
configuration program.
• If you select the bootp or dhcp option, IP is enabled but will not function until a
BOOTP or DHCP reply has been received. Requests will be broadcast
periodically by this device in an effort to learn its IP address. (BOOTP and DHCP
values can include the IP address, default gateway, and subnet mask).
• You can start broadcasting BOOTP or DHCP requests by entering an ip dhcp
restart command, or by rebooting the switch.
Note: Only one VLAN interface can be assigned an IP address (the default is
VLAN 1). This defines the management VLAN, the only VLAN through which you
can gain management access to the switch. If you assign an IP address to any
other VLAN, the new IP address overrides the original IP address and this
becomes the new management VLAN.
.
Example
In the following example, the device is assigned an address in VLAN 1.
Related Commands
ip dhcp restart (4-251)
ip dhcp restart
This command submits a BOOTP or DHCP client request.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• This command issues a BOOTP or DHCP client request for any IP interface that
has been set to BOOTP or DHCP mode via the ip address command.
• DHCP requires the server to reassign the client’s last address if available.
• If the BOOTP or DHCP server has been moved to a different domain, the
network portion of the address provided to the client will be based on this new
domain.
Example
In the following example, the device is reassigned the same address.