Asus GigaX2024SX - Manual (Page 255)

dot1x timeout tx-period
This command sets the time that the switch waits during an authentication
session before re-transmitting an EAP packet. Use the no form to reset to the
default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
ommand Mode
Interface Configuration
ample
C
Ex
show dot1x
This command shows general port authentication related settings on the switch or
a specific interface.
Syntax
show dot1x [statistics] [interface interface]
interface
• ethernet unit/port
- unit – Stack unit/port(Range:1-8)
- port - Port number.(Range:1-26)
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1x port
authentication is globally enabled on the switch
• 802.1X Port Summary – Displays the port access control parameters for
each interface, including the following items:
- Status –Administrative state for port access control.
- Operation Mode –Dot1x port control operation mode (page 4-112).
- Mode –Dot1x port control mode (page 4-111)
- Authorized –Authorization status (yes or n/a - not authorized).
• 802.1X Port Details – Displays detailed port access control settings for each
interface, including the following items:
- reauth-enabled – Periodic re-authentication (page 4-113).
- reauth-period – Time after which a connected client must be
re-authenticated (page 4-114).
- quiet-period –Time a port waits after Max Request Count is exceeded
before attempting to acquire a new client (page 4-114).
- tx-period – Time a port waits during authentication session
4-87