Asus GigaX2024SX - Manual (Page 44)

of the file name should not be a period (.), and the maximum length for file names
le to directly replace it. Note that the file “Factory_Default_Config.cfg”
ile, Copy. Select “tftp to startup-config” or “tftp to file” and
ck
on the TFTP server is 127 characters or 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• Source/Destination Unit – Specifies the switch stack unit number.
Note: The maximum number of user-defined configuration files is limited only by
available flash memory space.
Downloading Configuration Settings from a Server
You can download the configuration file under a new file name and then set it as
the startup file, or you can specify the current startup configuration file as the
destination fi
can be copied to the TFTP server, but cannot be used as the destination on the
switch.
Web – Click System, F
enter the IP address of the TFTP server. Specify the name of the file to download
and select a file on the switch to overwrite or specify a new file name, then cli
Apply.
Figure 3-11. Copy Configuration Setting
If you download to a new file name using “tftp to startup-config” or “tftp to file,” the
file is automatically set as the start-up configuration file. To use the new settings,
reboot the system via the System/Reset menu.
Note that you can also select any configuration file as the start-up configuration by
rt-Up page. using the System/File/Set Sta
3-19