Asus GigaX2024SX - Manual (Page 39)

Manual Configuration
Web – Click System, IP Configuration. Select the VLAN through which the
management station is attached, set the IP Address Mode to “Static,” enter the IP
address, subnet mask and gateway, then click Apply.
Figure 3-6. IP Configuration
CLI – Specify the management interface, IP address and default gateway.
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the switch to
be dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the
management station is attached, set the IP Address Mode to Static, DHCP or
BOOTP. Click Apply to save your changes. Then click Restart DHCP to
t a immediately request a new address. Note that the switch will also broadcas
wer reset. request for IP configuration settings on each po
3-14