Asus GigaX2024SX - Manual (Page 21)

2. At the Username prompt, enter “admin.”
3. At the Password prompt, also enter “admin.” (The password characters are not
isplayed on the console screen.)
nd the CLI displays the “Console#” prompt indicating
Exec level.
etting Passwords
ord
default user name and password “admin” to
access the Privileged Exec level.
2. Type “configure” and press <Enter>.
3. Type “username guest password 0 password,” for the Normal Exec level,
where password is your new password. Press <Enter>.
4. Type “username admin password 0 password,” for the Privileged Exec level,
d
4. The session is opened a
you have access at the Privileged
S
Note: If this is your first time to log into the CLI program, you should define new
passwords for both default user names using the “username” command, rec
them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case
sensitive.
To prevent unauthorized access to the switch, set the passwords as follows:
1. Open the console interface with the
where password is your new password. Press <Enter>.
Note: ‘0’ specifies the password in plain text, ‘7’ specifies the password in
encrypted form.
Setting an IP Address
gh the network. This can be done in either of the following ways:
et
u
You must establish IP address information for the switch to obtain management
access throu
Manual — You have to input the information, including IP address and subn
switch, yo mask. If your management station is not in the same IP subnet as the
will also need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or DHCP
address allocation servers on the network.
2-4