Asus GigaX2024SX - Manual (Page 322)

switchport mode
This command configures the VLAN membership mode for a port. Use the no
form to restore the default.
Syntax
switchport mode {trunk | hybrid | private-vlan}
no switchport mode
• trunk - Specifies a port as an end-point for a VLAN trunk. A trunk is a direct link
between two switches, so the port transmits tagged frames that identify the
source VLAN. However, note that frames belonging to the port’s default VLAN
(i.e., associated with the PVID) are sent untagged.
• hybrid - Specifies a hybrid VLAN interface. The port may transmit tagged or
untagged frames.
• private-vlan - For an explanation of this command see “switchport mode
private-vlan” on page 4-213.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following shows how to set the configuration mode to port 1, and then set the
switchport mode to hybrid:
Related Commands
switchport acceptable-frame-types (4-203)
switchport acceptable-frame-types
This command configures the acceptable frame types for a port. Use the no form
to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
• all - The port accepts all frames, tagged or untagged.
• tagged - The port only receives tagged frames.
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When set to receive all frame types, any received frames that are untagged are
assigned to the default VLAN.
Example
4-154