Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 133)

SierraNet M168 User Manual 131
Trigger and Filter Settings in Easy Mode Teledyne LeCroy
FCAV Patterns
 FCAV(Simple)
 FCAV(Extended)
2.6.22 Protocol Errors
Double‐click Protocol Errors to open the dialog.
Figure 2.83: Protocol Errors Dialog
Select the desired protocol errors or click on the Check All box to select all the errors.
Enter the count of the expected number of occurrences. Check the Check All box to select
ports P1 through P4 or individually select ports.
2.6.23 Trigger Setup
You can specify when the analyzer triggers. Two trigger modes are available: The default
mode is Snapshot or you can select Event Trigger.
When data capture starts with Don’t care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.