Dword matcher, 6 global rules – Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 User Manual

Page 217

Advertising
background image

    

SierraNet M168 Protocol Analyzer User Manual

215

InFusion Scenarios

  Teledyne LeCroy

Captured data dwords may also be used in the Substitute Data Dword Action. From the 
Action Properties screen, click on the DWORD Jam icon and click on Replace DWORD, 
choose Substitute For Custom Dword and then select the Substitute for property. 

A drop‐down menu is provided (see below) that allows the choice of a custom dword or 
any of the four captured dword registers. 

Figure 4.10: Using a Captured Data Dword in Substitute Dword Test Action

Dword Matcher

Dword Matcher is a dword pattern matcher that presents match and mask fields and a K‐
Code Mask field. K‐Codes are control characters that are always used in the first byte of a 
four‐byte ordered‐set. Of the K‐Code masks listed in the menu, D‐D‐D‐D is used for data 
bytes, and K‐D‐D‐D is used for all ordered‐sets.

When you create a dword match, keep the following in mind:

The pattern can be inside or outside of frames (it does not matter if the pattern 
is inside a frame or not).

Because the pattern can be inside or outside of frames, there is no offset.

You can make user‐defined ordered‐sets. (This is the reason this feature was cre‐
ated.)

You can use any K/D pattern.

4.5.6

Global Rules

Global Rules are a portion of the Scenario that can define only one test state. To create 
the Global Rules, you use the menu‐driven interface to enter an Event or Combined Event 
and the corresponding Action or set of Actions (the response of InFusion hardware to the 
Event).

In the case of a Combined Event, the Action is taken upon occurrence of any of the Events 
stated for the Event combination. It is a logical OR association, meaning any of the Events 
can trigger the Action.

After you enter the Event or Combined Event, the interface prompts you for Actions. An 
Action might be, for example, injecting a particular ordered‐set or error into the traffic 
stream. You can enter multiple Actions, which take place simultaneously. If one of the 

Advertising