External trigger – Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 User Manual
Page 83
SierraNet M168 User Manual
81
Trigger and Filter Settings in Easy Mode
Teledyne LeCroy
Auto Calibration
Click the Auto Calibration Settings.... button to display the Auto Calibration dialog.
Figure 2.56:
Auto Calibration
Dialog
Set the parameters for the following:
Port # ‐ Select the port.
Time Intervals(ms) ‐ Select the time interval from the drop‐down list.
Target Eye Width(%) ‐ Select the target eye width from the drop‐down list.
Fine Tune Threshold(%) ‐ Select the fine tune threshold from the drop‐down list.
PRBS Type ‐ Select value from the drop‐down list.
Status ‐ Progress bar indicating the status of calibration.
Calibrate ‐ Select Transceiver, Splitter or Transceiver & Splitter from the drop‐
down list.
External Trigger
Click the
icon to display the Device Settings dialog. Select the External Trig Settings
tab which shows the External Trig Out Setting and External Trig In Setting as High Active,
Low Active, or Toggle.