Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 227)

SierraNet M168 Protocol Analyzer User Manual 225
Running Scenarios Teledyne LeCroy
4.6.3 Summary of Scenario Creation
The suggested process of creating and executing a Scenario is as follows:
1. Create a Scenario in the library.
2. Drag and drop to create Global Rules Events and Actions and/or to create Sequence
and State Events and Actions.
3. Complete the Scenario and Save it.
4. Select the Scenario in the Library that you want to run on the device.
5. To run the Scenario, click the Start Session button. The device starts to monitor/
modify traffic.
4.7 Running Scenarios
If you use a library as a Scenario archive, then the process of executing a Scenario is as
follows:
Click on File > Open to open an existing File Library. The File Library displays all saved
Scenarios in that library and you can select a Scenario.
OR
Select a saved Scenario from the drop‐down list and click the Start Session button.
Figure 4.22: Running a Scenario
You can use a maximum of 255 states per sequence.
If you try to use more than 255 states, a red error message appears in the status area
of the application.