Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 90)

Teledyne LeCroy Trigger and Filter Settings in Easy Mode
88 SierraNet M168 User Manual
Link Control Frame
For any FCoE pattern, double‐click the pattern name, for example, double‐click Basic Link
Service to open the Basic Link Service Pattern dialog.
Note: Some screen captures for the FCoE patterns are similar to the screen capture shown below.
Figure 2.63: Basic Link Service Pattern Dialog
Enter the values for the Ether header, FCoE Header, Frame Header and the count of the
expected number of occurrences. Check the Check All box to select ports P1 through P8
or individually select ports.
Check the Trigger on given pattern with variable header length box to automatically
adjust the offset, if optional headers like VLAN tag, VNTag, etc. are present. Uncheck it, to
trigger for a pattern at a specific offset from the start of the frame.
The following additional FCoE patterns are available:
FCP Patterns
Frame Information Unit
 FCP Frame Information Unit (Any)
 FCP Frame Information Unit (Data)
 FCP Frame Information Unit (Confirm)
 FCP Frame Information Unit (XFER READY)
 FCP Frame Information Unit (Command)
 FCP Frame Information Unit (Response)