Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 User Manual
Page 71
SierraNet M168 User Manual
69
Trigger and Filter Settings in Easy Mode
Teledyne LeCroy
Manual Calibration
You can manually calibrate the probe settings.
Figure 2.43: Manual Calibration Dialog
Set the parameters for the following:
Port # ‐ Select the port.
RX Eq DC gain ‐ Select value from the drop‐down list.
RX Eq Control ‐ Select value from the drop‐down list.
Advanced ‐ Clicking Advanced displays the Advanced Probe Setting dialog (see
Figure 2.44
. Enter the desired values for each of the parameters.
Splitter ‐ Clicking Splitter displays the Splitter Settings dialog with the Serdes tab
selected. (see
Figure 2.45 on page 71
). Enter the desired values for each of the
parameters. Select the SFP tab (see
Figure 2.46 on page 72
) and enter the
desired values for each of the parameters. Select the Splitter tab (see
Figure 2.47
on page 73
) and enter the desired values for each of the parameters.
Restore Factory Settings ‐ Restores the factory settings.
Apply Selected Settings to All ‐ Applies the currently selected settings.