1 removing expansion cards – Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 User Manual
Page 18
Advertising
Teledyne LeCroy
Expandability
16
SierraNet M168 User Manual
1.4.1
Removing Expansion Cards
You can remove expansion cards using two tools:
Standard (flat blade) 3/16” screwdriver
Teledyne LeCroy Extraction Tool (part number 230‐0160‐00)
To remove an expansion card, follow these steps:
1. Unplug the system from AC power and turn the system so the expansion port is
facing you. Note the two retaining screws and the holes for the extraction tool that
are located on the panel of the expansion card.
2. Insert the extraction‐tool prongs into the holes in the expansion card panel.
Note:
If the prongs do not slip easily into the holes, use a small nail file or similar device to remove
paint from the prongs
Holes in the
Expansion Card
Advertising