Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 216)

Teledyne LeCroy InFusion Scenarios
214 SierraNet M168 Protocol Analyzer User Manual
#4, #5, #6 and #7. When trying to use the captured dword, for example in Replace Dword
Action, you can actually select from 8 captured dwords, numbered 0 through 7.
To capture a data dword, select Capture Dword from the Action Properties (see
Figure 4.8 on page 214 ). Select the location you would like the captured Dword to be
stored in, so it can be used in a later replacement or insertion.
Figure 4.8: Capture Data Dword Action
Using Captured Data Dwords
Captured data dwords can be used in creating Events for data that match the captured
dword(s), or in creating Actions to substitute or insert the captured dword(s) into the
data stream.
To create an Event using the captured dword, in the Add Event dialog (see Figure 4.9 on
page 214 ), select Dword Matcher and change the Type to the desired Captured Dword
number. Note that choice of a mask and an offset are still available. Select the code mask
from the drop‐down menu.
Figure 4.9: Using Captured Dword as an Event