Batch scenario, 1 using the batch scenario feature, Chapter 5: batch scenario – Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 User Manual
Page 229: Chapter 5
SierraNet M168 Protocol Analyzer User Manual
227
Chapter 5
Batch Scenario
5.1
Using the Batch Scenario Feature
You can run a sequence of executable scenarios to control both the Analyzer and the
Jammer automatically. A Scenario Batch file is a a list of commands to run in sequence
when you execute the file. A batch scenario can manage Jammer scenarios and Analyzer
recordings and their assigned ports and hardware in sequence. The system checks for
accuracy of inputs and commands.
Once a new Project is defined (see
“Starting a New Project” on page 36
) you can use the
Batch Scenario feature by selecting File>Batch to display the Batch Scenario Manager
dialog (see
Figure on page 237
). Batch Scenarios are part of a Project, and are saved as
such. Each Project file can have a unique set of different Batch Scenarios.
A batch scenario can be repeated up to 32 times. Branching to previous states is not
permitted to prevent infinite loops.