Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 209)

SierraNet M168 Protocol Analyzer User Manual 207
InFusion Scenarios Teledyne LeCroy
The following table lists the supported Actions. Note that some of these Actions only
apply to creating sequences.
TABLE 4.4: Test State Actions in Simple Mode
Action Description
Basic
Beep
Emits audible sound of duration selectable
via a drop‐down list.
Monitor Count
Opens a window to count the number of
Events that occur during a session. A
session is a time interval during which a
Scenario runs.
Auto Negotiation Jam
Opens a window to set Code Values, Code
Settings and General parameters (Ethernet
only).
Link Control
Disconnect ‐ puts both InFusion ports at
electrical idle immediately. This action is
only in effect while the scenario is running,
and the Jammer will reconnect the line
when the scenario is stopped.
Reconnect ‐ starts traffic pass‐through
immediately. This Action restarts traffic
after a previous disconnect command.
Once traffic is passing through, the
originator and responder resume link bring
up.
Symbol Jam
Replace with Another
Symbol
Replaces the Symbol with the selected
Symbol.
Remove [Replace
with Idle]
Removes the Symbol.
DWORD Jam
Replace DWORD
Replace DWORD (FC only).
Frame Jam
Insert Bytes Inside
Frame Allows to insert up to 60 Bytes inside the
frame, at the specified offset or at the
“current” dword, meaning the dword that
caused the Event.
Modify [Keep
Length] Allows to manipulate each dword in the
header, with the selected Action (click on
Pass though to get a drop‐down list).
Replace Replaces the whole frame with the
selected frame.
Remove [Replace
with IDLE] Removes the whole frame.
Truncate Removes some of the payload, as specified
in the Frame Length.