Agilent Technologies N2620A - Manual (Page 31)

Introducing the FrameScope Pro 1
N2620A User’s Guide 13
Checking Power and Charging the Battery
The FrameScope Pro battery should provide enough power for a
typical day of testing. The AC power adapter or charger can be
used to power the FrameScope Pro and recharge the battery.
To check the battery charge level, perform the following
procedure.
1 Switch on the FrameScope Pro, if necessary, by pressing
on the front of the FrameScope Pro.
2 Observe the battery icon on the Status display area on the
Main Menu screen.
The battery icon will show the remaining charge in the
battery (for example, 45%). If the battery level drops to 10%, a
warning message will be displayed. The FrameScope Pro will
function normally when the battery level is above 10%.
3 To recharge the battery or power the FrameScope Pro from
an AC power source, plug the DC power connector on the
adapter or charger into the 12 V DC connector on the side of
the battery.
4 Observe that the AC power icon is displayed on the Status
area.
N O T E
To shorten the charging time, Agilent recommends switching off the
FrameScope Pro while charging.
WA R N I N G
Do not operate the FrameScope Pro immediately after charging.
When the battery temperature exceeds 55 ºC (131 ºF), a “FrameScope
too hot” warning message will appear.