Agilent Technologies N2620A - Manual (Page 64)

46 N2620A User’s Guide
2 Network Testing with the FrameScope Pro
6 Press the Frame tab to configure the frame characteristics of
the traffic.
7 Press the box buttons to type in the Frame Type, MAC source,
MAC Destination
, and Data Pattern. Note that if you select an IP
frame type, there will be additional selections for IP Source
and IP Destination. Refer to
Chapter 8 , “Traffic Generation”
on page 239 for further details on these parameters.
8 Press Start to start the traffic generation. The summary of the
Traffic Generator activity screen is displayed. Press Details to
view more detailed results of the traffic generation.
The Frame Rate, TX Utilization, and Frame Length can be
adjusted using the up and down arrows on the Traffic
Generator summary screen.
During traffic generation, press Settings to set Error Frame
up to 1000 Frames each time, and select Tx or Rx pause
frame.