Allied Telesis AT-S63 - Manual (Page 102)

Chapter 6: Port Parameter Commands
102 Section I: Basic Operations
DISABLE SWITCH PORT
Syntax
disable switch port= port
Parameter
port Specifies the port to disable. You can specify more
than one port at a time. Port numbers are entered in
the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command disables a port. A disabled port does not forward traffic.
You might disable unused ports on the stack to prevent them from being
used by unauthorized individuals. The default setting for a port is enabled.
Example
This command disables ports 2.12 and 2.24:
disable switch port=2.12,2.24
Equivalent Command
set switch port= port status=disable
For information, see “SET SWITCH PORT” on page 108.