Reset switch – Allied Telesis AT-S63 User Manual
Page 77
AT-S63 Stack Command Line Interface User’s Guide
Section I: Basic Operations
77
RESET SWITCH
Syntax
reset switch [module=
id
]
Parameters
id
Specifies the ID number of a switch in the stack.
You can specify only one switch at a time. To
view the ID numbers of the switches, refer to
“SHOW STACK” on page 70.
Description
This command does the following:
Performs a soft reset on all of the ports on a switch or in a stack. The
reset takes less than a second to complete. The ports retain their
current operating parameter settings. To perform this function on a per-
port basis, refer to “RESET SWITCH PORT” on page 107.
Resets the statistics counters for all ports to zero. To perform this
function on a per-port basis, refer to “RESET SWITCH PORT
COUNTER” on page 124.
Deletes all dynamic MAC addresses from the MAC address table. To
perform this function on a per-port basis, refer to “RESET SWITCH
FDB” on page 134.
Examples
This command resets all of the ports in the stack:
reset switch
This command resets all the ports on chassis 2:
reset switch module=2