Reset switch port – Allied Telesis AT-S63 User Manual
Page 107
AT-S63 Stack Command Line Interface User’s Guide
Section I: Basic Operations
107
RESET SWITCH PORT
Syntax
reset switch port=
port
Parameter
port
Specifies the port to reset. You can specify more
than one port at a time. Port numbers are
specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command resets a port. The reset takes less that a second to
complete. You might reset a port if it is experiencing a problem
establishing a link with its end node. The port retains its current operating
parameter settings. To reset a port to the factory default settings, use
“PURGE SWITCH PORT” on page 106.
Example
The following command resets ports 3.5 to 3.8:
reset switch port=3.5-3.8
Equivalent Command
set switch port=
port
softreset
For information, see “SET SWITCH PORT” on page 108.