Allied Telesis AT-S63 - Manual (Page 104)

Chapter 6: Port Parameter Commands
104 Section I: Basic Operations
ENABLE SWITCH PORT
Syntax
enable switch port= port
Parameter
port Specifies the port to enable. You can specify more
than one port at a time. Port numbers are specified in
the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command enables a port. When a port is enabled, it forwards traffic.
The default setting for a port is enabled.
Example
The following command enables ports 2.1 to 2.4:
enable switch port=2.1-2.4
Equivalent Command
set switch port= port status=enable
For information, see “SET SWITCH PORT” on page 108.