Allied Telesis AT-S63 - Manual (Page 231)

231
Chapter 15
Spanning Tree Protocol Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 232
ˆ “DISABLE STP” on page 233
ˆ “ENABLE STP” on page 234
ˆ “PURGE STP” on page 235
ˆ “SET STP” on page 236
ˆ “SET STP PORT” on page 239
ˆ “SET SWITCH MULTICASTMODE” on page 241
ˆ “SHOW STP” on page 243
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For overview information on the spanning tree protocol (STP), refer
to the AT-S63 Management Software Features Guide.