Disable switch port flow – Allied Telesis AT-S63 User Manual
Page 103
Advertising
AT-S63 Stack Command Line Interface User’s Guide
Section I: Basic Operations
103
DISABLE SWITCH PORT FLOW
Syntax
disable switch port=
port
flow=pause
Parameter
port
Specifies the port where flow control is to be disabled.
You can specify more than one port at a time. Port
numbers are entered in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command deactivates flow control on a port. Flow control only applies
to ports operating in full duplex mode.
Example
The following command deactivates flow control on port 4.6:
disable switch port=4.6 flow=pause
Equivalent Command
set switch port=
port
flowcontrol=disable
For information, see “SET SWITCH PORT” on page 108.
Advertising