Allied Telesis AT-S63 - Manual (Page 197)

197
Chapter 13
Event Log and Syslog Client Commands
This chapter contains the following commands:
ˆ “ADD LOG OUTPUT” on page 198
ˆ “CREATE LOG OUTPUT” on page 200
ˆ “DESTROY LOG OUTPUT” on page 204
ˆ “DISABLE LOG” on page 205
ˆ “DISABLE LOG OUTPUT” on page 206
ˆ “ENABLE LOG” on page 207
ˆ “ENABLE LOG OUTPUT” on page 208
ˆ “PURGE LOG” on page 209
ˆ “SAVE LOG” on page 210
ˆ “SET LOG FULLACTION” on page 212
ˆ “SET LOG OUTPUT” on page 213
ˆ “SHOW LOG” on page 216
ˆ “SHOW LOG OUTPUT” on page 221
ˆ “SHOW LOG STATUS” on page 223
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
The event logs on the master switch are the only active logs in the
stack. The event logs on the member switches are inactive. For
background information about event logs and the syslog client, refer
to the AT-S63 Management Software Features Guide.