Allied Telesis AT-S63 - Manual (Page 272)

Chapter 17: Port-based and Tagged VLAN Commands
272 Section IV: Virtual LANs
SET VLAN
Syntax
set vlan= name | vid port= ports frame=tagged|untagged
Parameters
vlan Specifies the name or VID of the VLAN to be
modified.
ports Specifies the port whose VLAN type is to be
changed. You can specify more than one port at a
time. Port numbers are specified in the following
format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
frame Identifies the new VLAN type for the port. The type
can be tagged or untagged.
Description
This command changes a port’s VLAN type. You can use this command to
change a tagged port to an untagged port and vice versa.
Note the following before using this command:
ˆ Changing an untagged port to a tagged port adds the port to the
Default_VLAN as an untagged port.
ˆ Changing a port in the Default_VLAN from untagged to tagged results
in the port being an untagged member of no VLAN.
ˆ Changing a port from tagged to untagged removes the port from its
current untagged port assignment.
Examples
The following command changes port 2.4 in the Sales VLAN from tagged
to untagged:
set vlan=Sales port=2.4 frame=untagged