Allied Telesis AT-S63 - Manual (Page 26)

Chapter 1: Overview
26 Section I: Basic Operations
Supported Features
A stack supports the following AT-S63 Management Software features:
ˆ Port configuration
– Port status (enabled or disabled)
– Auto-Negotiation
– Speed
– Duplex-mode
– Flow control and backpressure
– MDI or MDI-X setting
– Packet filtering and rate limiting
ˆ Port statistics
ˆ Remote Telnet management
ˆ Static port trunks
ˆ Port mirroring
ˆ Event log
ˆ Syslog client
ˆ Class of Service
ˆ Spanning tree protocol (STP)
ˆ Rapid spanning tree protocol (RSTP)
ˆ Port-based and tagged VLANs
ˆ One IPv4 routing interface
All other features in the AT-S63 Management Software are automatically
deactivated when a stack is powered on.
Note
Because of the limited number of supported features, a stack may
not be suitable for some network environments. To utilize all the
features of the AT-9400 Switches, install the units as stand-alone
devices.