Allied Telesis AT-S63 - Manual (Page 277)

277
Chapter 18
Routing Interface Commands
This chapter contains the following commands:
ˆ “ADD IP ARP” on page 278
ˆ “ADD IP INTERFACE” on page 280
ˆ “DELETE IP ARP” on page 282
ˆ “DELETE IP INTERFACE” on page 283
ˆ “PURGE IP” on page 284
ˆ “SET IP ARP” on page 285
ˆ “SET IP ARP TIMEOUT” on page 287
ˆ “SET IP INTERFACE” on page 288
ˆ “SET IP LOCAL INTERFACE” on page 290
ˆ “SHOW IP ARP” on page 291
ˆ “SHOW IP COUNTER” on page 293
ˆ “SHOW IP INTERFACE” on page 295
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
Although the Internet Protocol version 4 packet routing feature of the
AT-9400 Switch is not supported in a stack, you can create one
routing interface so that the stack can have an IP address, which is
required by some of the management functions. For information,
refer to “Stack IP Address” on page 42 or the AT-S63 Management
Software Features Guide.