Allied Telesis AT-S63 - Manual (Page 206)

Chapter 13: Event Log and Syslog Client Commands
206 Section II: Advanced Operations
DISABLE LOG OUTPUT
Syntax
disable log output[= output-id ]
Parameters
output Specifies the output definition ID number to disable.
Not specifying an output definition disables all
definitions.
Description
This command disables an output definition. When disabled, no event
messages are sent to the specified device, although the definition still
exists. To permanently remove an output definition, see “DESTROY LOG
OUTPUT” on page 204. To enable the output definition again, see
“ENABLE LOG OUTPUT” on page 208.
Example
The following command disables (but does not delete) output definition
number 7:
disable log output=7
The following command disables all configured definitions:
disable log output