Enable switch port flow – Allied Telesis AT-S63 User Manual
Page 105
AT-S63 Stack Command Line Interface User’s Guide
Section I: Basic Operations
105
ENABLE SWITCH PORT FLOW
Syntax
enable switch port=
port
flow=pause
Parameter
port
Specifies the port where you want to active flow
control. You can specify more than one port at a time.
Port numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command activates flow control on a port. Flow control applies to
ports operating in full duplex mode. When flow control is activated, a port
sends out a PAUSE packet whenever it wants the end node to stop
sending packets.
Example
The following command activates flow control on port 1.5:
enable switch port=1.5 flow=pause
Equivalent Command
set switch port=
port
flowcontrol=enable
For information, see “SET SWITCH PORT” on page 108.