Allied Telesis AT-S63 - Manual (Page 188)

Chapter 12: File Download and Upload Commands
188 Section II: Advanced Operations
load method=xmodem destfile=cflash:product_sw.cfg
The following command downloads a new version of the AT-S63 image
file to the switch’s file system instead of the application block. It does this
by replacing the APPBLOCK option with a filename, in this case
“ats63v1_2_0.img”. The image file is stored in the switch’s file system with
this name:
load method=xmodem destfile=ats63v1_2_0.img
Since the file is stored in the switch’s file system and not the application
block, the switch does not use it as its active image file. If, at some point in
the future, you want to make it the active image file, use “LOAD
METHOD=LOCAL” on page 178.