Reset switch fdb – Allied Telesis AT-S63 User Manual
Page 134
Chapter 8: MAC Address Table Commands
134
Section I: Basic Operations
RESET SWITCH FDB
Syntax
reset switch fdb [port=
port
]
Parameter
port
Specifies the port whose dynamic MAC addresses are to
be deleted from the MAC address table. You can
specify more than one port at a time. Port numbers
must be specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command deletes all of the dynamic MAC addresses learned by the
entire stack or on a specific port. After a port’s dynamic MAC addresses
have been deleted, the port begins to learn new addresses.
Examples
The following command deletes all of the dynamic MAC addresses in the
stack’s MAC address table:
reset switch fdb
The following command deletes all of the dynamic MAC addresses
learned on port 2.5:
reset switch fdb port=2.5