Allied Telesis AT-S63 - Manual (Page 118)

Chapter 6: Port Parameter Commands
118 Section I: Basic Operations
SHOW SWITCH PORT
Syntax
show switch port[= port ]
Parameter
port Specifies the port whose parameter settings you
want to view. You can specify more than one
port at a time. Omitting this parameter displays
all ports. Port numbers are entered in the
following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command displays a port’s current operating specifications, such as
speed and duplex mode. The command displays the following port
information. (For an example of the information displayed by this
command, see Figure 14 on page 122.)
ˆ Port Description - Displays the name of the port. The default name is
“Port_” followed by the port number. To configure a port’s name, refer
to “SET SWITCH PORT” on page 108.
ˆ Port Type - Displays the IEEE standard of a port. For example, the port
type for a twisted pair port on an AT-9424T/SP switch is 10/100/
1000Base-T.
ˆ Status - Displays whether the port is currently enabled or disabled.
When disabled, a port does not forward network traffic. The default is
enabled. To disable or enable a port, refer to “DISABLE SWITCH
PORT” on page 102, “ENABLE SWITCH PORT” on page 104, or “SET
SWITCH PORT” on page 108.
ˆ Link State - Displays the current link state between the port and the
end node. If the port has established a link with an end node, link state
will be “Up.” If there is no link, link state will be “Down.”
ˆ Configured Speed/Duplex - Displays the current configured settings for
speed and duplex mode on the port. The setting of “Auto” indicates the
port has been set to Auto-Negotiation, the default setting. To adjust a
port’s speed and duplex mode, refer to “SET SWITCH PORT” on
page 108.
ˆ Configured MDI Crossover - Displays the current configured setting for
MDI/MDIX on the port. If the port is set to Auto-Negotiation, this field