Restart reboot – Allied Telesis AT-S63 User Manual
Page 79
AT-S63 Stack Command Line Interface User’s Guide
Section I: Basic Operations
79
RESTART REBOOT
Syntax
restart reboot
Parameters
None.
Description
This command resets the entire stack. The switches run their internal
diagnostics, load the AT-S63 Management Software, and perform the
discovery process. The reset can take several minutes to complete. For
further information, refer to “Discovery Process” on page 32.
Note
The switches of a stack do not forward traffic during the reset
process. Some network traffic may be lost.
Note
Be sure to use the SAVE CONFIGURATION command to save your
changes before resetting the stack. Any unsaved changes are lost.
Your local or remote management session with the stack ends when it is
reset. You must reestablish the session to continue managing it.
Example
The following resets the stack:
restart reboot