Allied Telesis AT-S63 - Manual (Page 123)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 123
Setting Up Rate Limiting
The rate limiting feature allows you to set the maximum number of ingress
packets the port accepts each second. Packets exceeding the threshold
are discarded. You can enable rate limiting and set a rate independently
for unknown unicast, multicast, and broadcast packets.
To set rate limiting, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 25 on page 112.
2. From the Port Configuration menu, type 1 to select Port Configuration.
The following prompt is displayed:
Enter port-list ->
3. Enter the number of the port you want to configure.
The Port Configuration menu is shown in Figure 26 on page 113.
4. From the Port Configuration menu, type 5 to select Rate Limiting.
The Rate Limiting menu is shown in Figure 30.
Figure 30. Rate Limiting Menu
5. From the Rate Limiting menu, type 1 to toggle Unknown Unicast Rate
Limiting Status between Enabled and Disabled.
6. Type 2 to select Unknown Unicast Rate.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Rate Limiting
Configuring Port 11
1 - Unknown Unicast Rate Limiting Status ... Disabled
2 - Unknown Unicast Rate ................... 262143 packets/second
3 - Multicast Rate Limiting Status ......... Disabled
4 - Multicast Rate ......................... 262143 packets/second
5 - Broadcast Rate Limiting Status ......... Disabled
6 - Broadcast Rate ......................... 262143 packets/second
R - Return to Previous Menu
Enter your selection?