Allied Telesis AT-S63 - Manual (Page 612)

Chapter 25: Port-based and Tagged VLANs
612 Section VI: VLANs
Creating a New Port-based or Tagged VLAN
To create a new port-based or tagged VLAN, perform the following
procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 207.
Figure 207. VLAN Configuration Menu
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
Note
If selection 4, Configure VLANs, is not displayed in the menu, the
switch is running in a multiple VLAN mode. To change a switch’s
VLAN mode, refer to “Selecting a VLAN Mode” on page 668.
Selection 8, Configure GARP-GVRP, is described in Chapter 26,
“GARP VLAN Registration Protocol” on page 635.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
VLAN Configuration
1 - Ingress Filtering Status ........ Disabled
2 - VLANs Mode ...................... User Configured VLANs
3 - Management VLAN ................. 1 (Default_VLAN)
4 - Configure VLANs
5 - Show VLANs
6 - Show PVIDs
7 - Configure GARP-GVRP
R - Return to Previous Menu
Enter your selection?