Allied Telesis AT-S63 - Manual (Page 436)

Chapter 22: SNMPv3
436 Section IV: SNMPv3
11. Enter the User Name of the User Table you want to modify.
The following prompt is displayed:
Enter Authentication Protocol [M-MD5, S-SHA, N-None]:
12. Enter one of the following:
M-MD5
This value represents the MD5 authentication protocol. With this
selection, users (SNMP entities) are authenticated with the MD5
authentication protocol after a message is received. This algorithm
generates the message digest. The user is authenticated when the
authentication protocol checks the message digest. With the MD5
selection, you can configure a Privacy Protocol.
S-SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication
protocol after a message is received. This algorithm generates the
message digest. The user is authenticated when the authentication
protocol checks the message digest. With the SHA selection, you can
configure a Privacy Protocol.
N-None
This value represents no authentication protocol. When messages are
received, users are not authenticated. With the None selection, you
cannot configure a Privacy Protocol.
If you select None, go to step 9.
If you select MD5 or SHA, the following prompt is displayed:
Enter Authentication Password:
13. Enter an authentication password of up to 32 alphanumeric characters.
The following prompt is displayed:
Re-enter Authentication password:
14. Re-enter the password.
The following message is displayed:
Authentication protocol algorithm has been changed.
The following prompt is displayed:
Please enter privacy password to regenerate privacy key.
15. Enter the Privacy Password for this User Name.
The following prompt is displayed: