Allied Telesis AT-S63 - Manual (Page 281)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 281
The following prompt is displayed:
Enter output ID to modify [0 to 20] ->
5. Enter the number of the log output that you want to modify.
The Syslog Output Configuration menu is displayed, as shown in
Figure 82 on page 276.
6. Refer to “Creating a Log Output Definition” on page 275 for information
about the menu selections.
7. When you complete the modifications, type M to select Modify Log
Output.
The Configure Log Outputs menu as shown in Figure 81 on page 275
is redisplayed.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting a Log
Output
To delete a log output definition you have already created, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 77 on page 263.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 81 on page 275.
4. From the Configure Log Outputs menu, type 3 to select Modify Log
Output.
The following prompt is displayed:
Enter output ID to delete [2 to 20] ->
5. Enter the number of the log output that you want to delete.
The following prompt is displayed:
Are you sure you want to delete output ID x? [Yes/No] ->
6. Enter Y for Yes or N for No and press Enter.
If you enter Y, the output ID you selected is deleted.