Resetting mstp to the defaults – Allied Telesis AT-S63 User Manual
Page 595
Advertising
AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols
595
Resetting MSTP to the Defaults
To reset MSTP to the defaults, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 178 on
page 535.
2. From the Spanning Tree Configuration menu, type 3 to select Configure
Active Protocol.
The MSTP menu is shown in Figure 195 on page 569.
3. From the MSTP menu, type D to select Reset MSTP to Defaults.
The following message is displayed:
Do you want to reset MSTP configuration to default? [Yes/
No] ->
4. Enter Y for Yes or N for No and press Return.
The MSTP configuration is reset to the defaults.
Advertising