Allied Telesis AT-S63 - Manual (Page 242)

Chapter 12: File Downloads and Uploads
242 Section II: Advanced Operations
Caution
This procedure causes the switch to reset. Some network traffic may
be lost.
To upload a boot configuration file on the master switch to another switch
in an enhanced stack, perform the following procedure:
1. From the Main Menu, type 8 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 17 on page 88.
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The “2 - Stacking Services” selection is available only on master
switches.
The Stacking Services menu is shown in Figure 18 on page 89.
3. From the Stacking Services menu, type 1 to select Get/Refresh List of
Switches. The master switch polls the subnet for other enhanced
stacking switches in the same enhanced stack and displays the
switches in the Stacking Services menu.
4. Type 5 to select Load Configuration File.
The following prompt is displayed:
Remote switches will reboot after load is complete
Do you want to load the last saved master configuration?
[Yes/No] ->
5. If you want to upload the master switch’s active boot configuration file
onto the other switch, type Y for yes and go to step 7. If you want to
upload a different configuration file from the master switch, type N for
no.
The following prompt is displayed:
Enter the configuration file name ->
6. Enter the name of the configuration file stored in the master switch’s
file system you want to upload. The name must include the suffix
“.cfg”. (To view the names of the configuration files, refer to “Displaying
System Files” on page 220.)