Allied Telesis AT-S63 - Manual (Page 265)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 265
6. To display events of a selected severity, type 5 to select Display
Severity.
The following prompt is displayed:
Enter Severity levels to display (ALL, E - Error, W -
Warning, I - Information, D - Debug) ->
The possible options are:
ALL
All messages of the following types are displayed. This is the default.
E - Error
Only error messages are displayed. Error messages indicate that the
switch operation is severely impaired.
W - Warning
Only warning messages are displayed. These messages indicate that
an issue may require manager attention.
I - Information
Only informational messages are displayed. Informational messages
display useful information that you can ignore during normal operation.
D - Debug
Debug messages provide detailed high-volume information that is
intended only for technical support personnel.
You can select more than one severity at a time, separated by a
comma, for example, E,W.
7. To view the events of a particular AT-S63 software module, type 7 to
select Event Module.
The list of modules is displayed. The AT-S63 management software
consists of modules, each responsible for a different part of switch
operation. You can instruct the switch to display only those events that
were generated by specific modules.
8. Enter the modules whose event messages you want to view. To
specify more than one module, separate them by a comma—for
example, “system, stp, ptrunk.” The default is ALL, which displays the
events for all modules.